| M6500R302H | 85-95 MUSTANG 5.0/5.8L PERFORM | 1 | 1 | 0 | $179.99 | $179.99 | RETURN THIS ITEM | |
| CCA-782616 | 85-95 MUSTANG 5.0L COMP CAMS H | 1 | 1 | 0 | $40.95 | $40.95 | RETURN THIS ITEM | |
| TFS-2500100 | 79-95 MUSTANG 5.0L/5.8L TRICK | 1 | 1 | 0 | $186.99 | $186.99 |
Whats your oil
I haven't started the car it has the intake off and I just put the heads and rocker arms on idkWhats your oil pressure?
Thanks, that's what I thought so I took a pushrod and lifter out and they are the same , I will try what you said tomorrow, what if the arms still have play after I do that? the only ones that are tight are the ones with the lifters raised up
I always check old parts against the new ones, so lifters are same height?push rods same length?,ect.
Then adjust rockers properly( if you dont know , find out) Me I use the turn motor over till the rocker I'm working on is on base of cam then roll push rod
between my fingers and tighten down till push rod has resistence,then 1\2 turn more.
Just my two cents.
I always check old parts against the new ones, so lifters are same height?push rods same length?,ect.
Then adjust rockers properly( if you dont know , find out) Me I use the turn motor over till the rocker I'm working on is on base of cam then roll push rod
between my fingers and tighten down till push rod has resistence,then 1\2 turn more.
Just my two cents.
Okay is this a good video to off ofU Tube it. Nickyb's way is right.
Going to disagree with you... A TERRIBLE confusing video....
I agree, not good.Going to disagree with you... A TERRIBLE confusing video....
No I haven't how do you do that? it feels like there only moving because the lifter gets pushed downOn every stock 5.0 I've taken the factory rockers were a little loose. Have you tried using a drill to prime your oil system? Once you get everything pumped up the rocker might tighten up.
Is this for stock rocker arms ?I agree, not good.
we have a write up in the tech/how to thread.
Install - Installation Of Ford Racing (and Other) Stud/pedestal Mount Roller Rockers
Gearbanger 101 submitted a new resource: Installation of Ford Racing (and other) Stud/Pedestal Mount Roller Rockers - Roller, Rocker, Stud, Pedestal, Ford Racing, FRPP, M-6564-ALL Click the download sidebar above for printable PDF format. Read more about this resource...www.stangnet.com
YeahAre your pushrods new, and old the same length?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?