Build Thread My Never Ending 89 Notch Thread

So today's fun goes something like this . I got the covers all ready to go on extra line and fittings . Fiddle with the drivers side after getting it down move over to pass side and bang doesn't clear the power pipe .

Now I love these damn covers . But honestly I am just so tired of going nuts modifying that I'm not ready to cut them up and make it work .

So my new plan goes as follows . Shorten up pass side line to meet where the breather hole is and have a 10an fitting welded in it . Then use my old efi cover with no hole and weld a bung out of the front cuz the breather hole will not clear the intake if a fitting was welded in on the driver side cause of my intake .

Also replaced my bluish 6k headlights for 5k after the pass side ballast took a. Dump I bought another kit and took car of the that .

Blower drain back line kept seeping oil between the fittings I used for it even after I re did them once . So I orderd aero quip fittings for it and took care of that tonight hopefully that solves that issue as well .

The start of the valve covers . Was loving them too

then this .




New fitting will go as follows with a 180 degree fitting in it .
Other side will use the carb style and fitting will go where the round breather hole is

Sent from my iPhone using my fingers while my auto correct makes me seem illiterate