Build Thread My Never Ending 89 Notch Thread

hoopty5.0 · Mar 30, 2019

That’s a serious fkn pump

General karthief · Mar 30, 2019

Just wondering, why not an in tank pump?

stanglx2002 · Mar 30, 2019

General karthief said:
Just wondering, why not an in tank pump?

I thought the same thing

General karthief · Mar 30, 2019

I'm working on a Holley Sniper setup (long story, not my car) and they have in tank pumps that support stupid hp numbers.

TOOLOW91 · Mar 30, 2019

I had one and had nothing but issues burning them up. Nothing but issues venting too . So I went external with the MagnFuel so I can change it or access it if I have an issue without it being crazy to do . Also even though they work 2-3 pumps stages or continuous im not crazy about either in the tank

I got a good deal on the pump it was new just opened in the. Box . So selling the a 1000 stealth setup covered it and still no sump tank so looks Stock from behind.

It’s a glens tank . Using a 6an rollover vent now . Went from 8 feed and 6 return with 6 at rails to

10 feed 8 return and 8 at rails

TOOLOW91 · Apr 16, 2019

So i was away for almost a week and a half . Went to WV to ride Hatfield McCoy trails which was insane .

Got back on the car last night . Mounted meth pump . Finished -10 line back and secured it . Finished the return line adapter . Need one 10 90 degree fitting and I’m good to go as well as new fuel filters .

Rails should be here to tomorrow so I can finalize fuel system .

Laid all the trunk carpet just kind of in place with no clips and cut and trimmed for all the new wire everywhere . New center carpet and spare tire cover board on order to support the carpet .

Again just mock up . Full trunk carpet because street car !

Meth tank will get mounted next and then that’s complete as well

hoopty5.0 · Apr 16, 2019

I thought you had a suzuki Z400?

TOOLOW91 · Apr 16, 2019

hoopty5.0 said:
I thought you had a suzuki Z400?

Sold it last year cuz it was sitting . I do miss it . Took my boys 400ex .

TOOLOW91 · Apr 18, 2019

Final mock up . Waiting on new trunk carpet and the board to come that used to cover the spare tire but meth kit is finished

Noobz347 · Apr 18, 2019

stanglx2002 said:
Where is @Noobz347 or @General karthief to comment on the oil feed contraption

Car looks awesome TOOLOW!

TOOLOW91 · Apr 19, 2019

Gas tank is officially In it’s home . Feed and return done . These showed up as I was leaving for my hair cut

RangerJoe · Apr 19, 2019

TOOLOW91 said:
Gas tank is officially In it’s home . Feed and return done . These showed up as I was leaving for my hair cut

Hair cut??? What's that? Been about 10 years since I had to worry about one of those, lol. Cars looking good man.

Joe

TOOLOW91 · Apr 21, 2019

Fuel lines are 99 percent done . Just need to order one more straight . Rails , injectors , and harness in.

Trans pan up with the Moroso gasket just have to set up shifter cable .

TOOLOW91 · Apr 21, 2019

TOOLOW91 · Apr 21, 2019

Decided to finally tighten the steering shaft . Re connect the tie rods . Set the toe by eye and set the ride height . I can’t explain what I felt to see this car back on the ground again . At its natural stance .

Davedacarpainter · Apr 22, 2019

TOOLOW91 said:
Decided to finally tighten the steering shaft . Re connect the tie rods . Set the toe by eye and set the ride height . I can’t explain what I felt to see this car back on the ground again . At its natural stance .

Man, you sure are getting close. That’s been a lot of work, huh Jeff?

TOOLOW91 · Apr 22, 2019

Davedacarpainter said:
Man, you sure are getting close. That’s been a lot of work, huh Jeff?

A lot is an understatement man . There is still a bunch to go but I’m in the home stretch I think .

I’m basically a one man show too , I have friends who I trust to help me but I am just picky . Plus I work 3-11 so this car is being built in the early am hours when normal people sleep lol

James V · Apr 22, 2019

TOOLOW91 said:
Decided to finally tighten the steering shaft . Re connect the tie rods . Set the toe by eye and set the ride height . I can’t explain what I felt to see this car back on the ground again . At its natural stance .

Looks great! What size cowl is that?

TOOLOW91 · Apr 22, 2019

James V said:
Looks great! What size cowl is that?

2.5 . Thanks bro !!

James V · Apr 22, 2019

TOOLOW91 said:
2.5 . Thanks bro !!

Love the wheels too. I think I might eventually get a 2.5 or 3", I currently have a 5" and it's a little too much

Build Thread My Never Ending 89 Notch Thread

mechanicus terribilis

wonder how much it would cost to ship you a pair

CT Material here

wonder how much it would cost to ship you a pair

If you're the village idiot what's that make me?

If you're the village idiot what's that make me?

mechanicus terribilis

If you're the village idiot what's that make me?

If you're the village idiot what's that make me?

Stangnet Facilities Maint Tech... Er... Janitor

If you're the village idiot what's that make me?

I leave the horn on while driving

If you're the village idiot what's that make me?

If you're the village idiot what's that make me?

Attachments

If you're the village idiot what's that make me?

Chicks can make things hard if they’re inspired...

If you're the village idiot what's that make me?

If you're the village idiot what's that make me?

Similar threads

Privacy & Transparency

Privacy & Transparency