Non intercooled at the moment .That's kinda crazy man. If that can gets heat soaked and your oil is at operating temp, there should be that much vapor in the path to be separated. Water injection perhaps? After-cooler?
Non intercooled at the moment .That's kinda crazy man. If that can gets heat soaked and your oil is at operating temp, there should be that much vapor in the path to be separated. Water injection perhaps? After-cooler?
Hey, i like your tint, what percent did you get? And are they different percents on your doors vs rear glass?
They have never had rubber since I put them on . The hood does have the stock rubber bumpers that sit in the fenders though .Whats going on there with your hood studs? I noticed no rubber?
Thats cool. Most of my alignment issues were around the headlights. Thanks for the info.
PS: I installed a gopro under the hood and drove around. Then adjusted the bumpers up to touch the hood and the difference was amazing. Couldn't see it while driving. gopro's rock.
The dividers ? They are the ford licensed pro form ones that have the ford logo on them .Looking good man, what kind of wire looms are those?
Thanks man . I was really ocd about not wanting to lose the little vent adjuster knobs even though they don't do much . And I don't like a million gauges on the pillar .Nice. Those dam tstats. I like the auto meter vent/gauge pod.
Sent from my Samsung Note 4 using Tapatalk
Thanks man . I was really ocd about not wanting to lose the little vent adjuster knobs even though they don't do much . And I don't like a million gauges on the pillar .
Cuts it down big time. They still work but more for show i guess.How is the air flow coming out of them? I imagine it cuts down a lot